IpagonConnect your device
For iPhone and iPad with iOS / iPadOS 27 or later. Set up once on the device you want to install apps on.
Sign in to Ipagon and select a profile, then return to this guide in the same app or browser.
Sign inChecking your session…
Download your .conf file
Save this profile’s file to Files. Each device needs a separate Ipagon profile and its own .conf file.
Import and enable the tunnel
Open WireGuard → + → Create from file or archive. Select the .conf file from step 2, allow the VPN configuration and turn on the new Ipagon tunnel. Turn off any older Ipagon tunnel for another device.
During setup and installation, keep the selected tunnel on and the device unlocked.
Pair in LL Pair
- Open LL Pair, allow Local Network access and follow its Developer Mode instructions. After a restart, confirm Developer Mode and reopen LL Pair.
- Tap Start Pairing. Open Settings → Privacy & Security → Developer Mode → LL Pair. Enter the PIN shown in LL Pair and wait for pairing to finish. Keep the LL Pair entry.
Save the pairing file
In LL Pair, tap Save Pairing File → Save to Files. Remember the folder you choose.
Upload and connect
Unlock the device and select the LL Pair file from step 6. After verification, apply the connection below.
Verification does not replace the saved connection until you apply it.
My AppsInstall an app
Open My Apps, tap + and choose an IPA. Then tap Install: it starts immediately.
My Apps →Troubleshooting
If LL Pair is missing in Developer Mode, return to LL Pair and tap Start Pairing. If a configured device cannot be reached, restart it once and reconnect the tunnel. Keep its existing pairing.